Quantum-composers 9530 Series Manuel d'utilisateur télécharger pdf (Page 17)

9530/8530 Manual Version 4.8 Page 17

Setting System Mode of Operation

By pressing the Menu button the system mode menu can be accessed. The system Mode menu

sets the T

system timer mode. The mode may be changed by setting the cursor on the mode row

and pressing the up and down key. By pressing the next button while in this menu will allow the

user to change between setting the mode or the parameter. The menu will show the extra set of

parameters (Brst, On & Off) only when they are applicable.

Mode:

Parameters:

Continuous

N/A

Single Shot

N/A

Burst

Brst:

‘N’ number of pulses to generated for each T

pulse

Duty Cycle

On/Off:

‘N’ number of pulses to generated for each T

pulse / ‘M’ number of pulses to inhibit for each

pulse

*NOTE: Any mode may be started by either the RUN/STOP key in the internal trigger mode or

armed by the RUN/STOP key and started by an external trigger in the external trigger

mode. In the single shot and burst modes, (internally triggered) the unit disarms itself

at the end of the pulse train. Pressing the RUN/STOP key after the unit has been

disarmed will generate a new pulse train.

Clock/Rate Menu

Rate:

Source: Ext Osc

Rate: 100 MHz

Level: 0.50 Volts

Ref Out: T

Pulse

Source: Int Source

Press the Page Button

Change Clock Sources

Ref Out: T

Pulse

Level: 0.50 Volts

Source: Ext w/ PLL

Rate: 100 MHz

Level: 0.50 Volts

Ref Out: T

Pulse

Ext Opt: Force Off

Level: 0.50 Volts

Rate: T

Rate:

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 70 71

Commentaires sur ces manuels

Pas de commentaire

Quantum-composers 9530 Series Manuel d'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Générateurs Quantum-composers 9530 Series