Quantum-composers 9500 Plus Series Manuel d'utilisateur télécharger pdf (Page 22)

System Mode Menu

Mode

MODE:

Continuous

MODE: Single

Shot

MODE:

Burst

MODE: Duty

Cycle

# /

Burst

Off

Cycle

Setting System Mode of Operation

The MODE menu sets T

system timer mode. The menu will show the extra

set parameters (Burst, On & Off) only when they are appropriate.

• Mode: Selects the T

mode: Continuous, Single Shot, Burst

or Duty Cycle mode.

• Burst: Sets the number of pulses to be generated when in

Burst mode.

• On: Sets the number of pulses to be generated during each

on cycle.

• Off: Sets the number of pulses to skip each during off cycle

when in the Duty Cycle mode.

*NOTE: Any mode may be started by either the RUN/STOP key in the

internal trigger mode or armed by the RUN/STOP key and started by an

external trigger in Gate/Trig menu in the external trigger mode. In the single

shot and burst modes, (internally triggered) the unit disarms itself at the end

of the pulse train. Pressing the RUN/STOP key after the unit has been

disarmed will generate a new pulse train.

Channel Menus

Timing

Parameters

Pulse

Configuration

Pulse

Configuration

Pulse

Configuration

Pulse

Configuration

Enable Enable

Enable Enable Enable

Sync Source Polarity

Mode

Help Line

Pulsewidth Output Type

On Cycle Gate Enable Mux

Delay Output Level

Off Cycle / Burst Wait

Enabling Channel Output

At the top of each of the channel menu pages is a parameter to enable or

disable the channel. Each channel may be individually controlled.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 69 70

Commentaires sur ces manuels

Pas de commentaire

Quantum-composers 9500 Plus Series Manuel d'utilisateur Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Générateurs Quantum-composers 9500 Plus Series