Quantum-composers 9250 Series Manuel d'utilisateur télécharger pdf (Page 16)

9250 Manual Version 1.2 | Quantum Composers

Basic Operation

The following steps must be carried out before communication with the 9250 may take place:

 Ensure that the proper drivers have already been installed on the remote computer.

These drivers will need to be installed for the remote computer to interface to the 9250.

Reference the “9250 Setup  USB” section for more information on installing the proper

drivers.

 Open the 9250 application by double clicking on the application which can be found on

the included CD.

 Once the 9250 application recognizes the COM Port the 9250 is attached to, a

connection will be established, and communication may now be carried out.

 A COM Port does not need to be selected as the computer will automatically recognize

the 9250. If multiple 9250 units are connected to the same computer, multiple instances

of the GUI may be run. The first application instance will connect to the 9250 on the

lowest COM Port, followed by the next application connecting to the 9250 on the next

highest COM port.

*Note: Parameters on the GUI that are not applicable with the selected settings will be greyed

out and won’t be able to be adjusted until the appropriate settings have been selected.

(Example: The System’s Burst Count cannot be adjusted until the System is set to Burst

Mode.)

System Section

The System Section of the 9250 application only affects the 9250’s system parameters. As

shown below in Figure 6.2, the following system parameters may be altered:

Figure 6.2 –9250 Application: System Parameters

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 50 51

Pas de commentaire

Quantum-composers 9250 Series Manuel d'utilisateur Page 16