Quantum-composers 9250 Series Manuel d'utilisateur télécharger pdf (Page 9)

9250 Manual Version 1.2 | Quantum Composers

4. Pulse Concepts and Pulse Generator Operations

Counter Architecture Overview

*Start source is:

Run/Stop button/function in Internal Modes

External input in External Trigger modes

*TRG command via Serial access

**Channels are armed by the Run/Stop function (external button or through 9250 application).

In single shot and burst modes channels may be rearmed by pressing the RUN button

again.

System Timer Functions

The System Timer functions as a non-retriggerable, multi-vibrator pulse generator. This

means that once started, depending on the mode, the timer will produce pulses

continuously. Before pulses can be generated, the timer must be armed and then receive a

start pulse. Arming the counter is done by enabling the Run/Stop function by either the

external button or through the 9250 application. With external trigger disabled, the Run/Stop

function also generates the start command for the counter. With external trigger enabled,

the external trigger provides the start pulse. In either case, once started, the counter

operation is determined by the System Mode Generator. Standard modes include:

 Continuous

Once started T

pulses are generated continuously.

 Single Shot

One T

pulse is generated for each start command.

 Burst

‘N’ T

pulses are generated for each start

command.

 Duty Cycle

Once started T

pulses cycle on and off

continuously.

The T

pulse is distributed to all of the start inputs of the Channel Timers and Mode

Generators.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 50 51

Pas de commentaire

Quantum-composers 9250 Series Manuel d'utilisateur Page 9